Honeywell CSP-C Manual do Utilizador descarregar pdf

IND.CONT.EQ.

3JHX

INSTALLATION INSTRUCTIONS

62-0242—01

Solid Core and Split Core Adjustable

Current “Status” Switches

CSS-O, CSS-C; CSP-O, CSP-C

SAFETY

WARNING

For CSS-O,C ensure that all power sources

are disconnected and locked out before

installation as severe injury or death may

result from electrical shock due to contact

with high voltage wires.

CAUTION

This product is not intended to be used for life

or safety applications.

CAUTION

This product is not intended for use in any

hazardous or classified locations.

INSTALLATION

Make sure that all installations are in compliance with all

national and local electrical codes. Only qualified

individuals that are familiar with codes, standards and

proper safety procedures for high voltage installations

should attempt installation. The current switches will not

require external power, since the power for the current

switch is induced from the conductor being monitored.

WARNING

Never rely on the LEDs to determine whether

power is present at the current switch. The

red LED will indicate whether the current is

above the adjustable trip point. The green

LED will indicate whether the current is below

the adjustable trip point.

IMPORTANT

The current switch should be used on insulated

conductors only!

The current switch may be mounted in any position using

the (2) #8 x 3/4 in. (19 mm) Tek screws and the mounting

holes in the base or snapped directly on to the 1-3/8 in.

(35 mm) DIN rail (See Figures 1 and 2). Leave a

minimum distance of 1 in. (25 mm) between the current

switch and any other magnetic devices, such as

contactors and transformers.

For applications in which the normal operating current is

below the 0.8/2.0 Amps trip point (See Fig. 3), the

conductor being monitored may be looped through the

sensor 6/12 times giving you a total operating current of

6/12 times the original current.

Example:

A small fan operating at 0.2 Amps can be wrapped

through the sensor 6 times to give you a total

operating current of 1.2 Amps flowing through the

CSS-O-A300-001. Another option is to use CSS-O-

A200-001.

A small fan operating at 0.2 Amps can be wrapped

through the sensor 16 times to give you a total

operating current of 3.2 Amps flowing through the

CSP-O-A300-001. Another option is to use the

CSP-O-A200-001.

Fig. 1. Sensor placed on DIN rail

M25289

1 2 3 4

Resumo do Conteúdo

Página 1 - Current “Status” Switches

IND.CONT.EQ.3JHXINSTALLATION INSTRUCTIONS62-0242—01Solid Core and Split Core AdjustableCurrent “Status” SwitchesCSS-O, CSS-C; CSP-O, CSP-CSAFETYWARNIN

Página 2 - Latch Operation

SOLID CORE AND SPLIT CORE ADJUSTABLE CURRENT “STATUS” SWITCHES62-0242—01 2Fig. 2. Sensor removed from DIN railFig. 3. Wires through sensorsWARNINGThe

Página 3 - OPERATING SPECIFICATIONS

SOLID CORE AND SPLIT CORE ADJUSTABLE CURRENT “STATUS” SWITCHES3 62-0242—01Fig. 6. Opening with a screwdriverWiringHoneywell recommends the use of a 2

Página 4 - TROUBLESHOOTING

SOLID CORE AND SPLIT CORE ADJUSTABLE CURRENT “STATUS” SWITCHESAutomation and Control SolutionsHoneywell International Inc. Honeywell Limited-Honeywell