Honeywell CT87K Manual do Utilizador descarregar pdf (Página 4)

CT87N/CT87K • Owner's Manual

69-1959EFS—02 4

1. Align the slots on the base with tabs on

the thermostat, then push gently until the

thermostat snaps into place.

2. Restore electrical power at the heating/

cooling system, or at the fuse/circuit-

breaker panel.

Move the switch to the proper setting for your

system:

F: For gas or oil heating systems, leave the

fan operation switch in this factory-set position

(forsystemsthatcontrolthefaninacallfor

heat).

E: Change the switch to this setting for heat

pump or electric heatsystems.(Thissetting

is for systems that allow the thermostat to

control the fan in a call for heat, if a fan wire is

connected to the Gterminal.)

Set fan operation switch (CT87N)

Finish installation

Base

Heating System Switch 1 Switch 2

Steam or gravity On On

High efficiency warm air Off On

(90%plusefficiency),

hot water, or heat pump

Gas or oil warm air Off Off

(factorysetting)

Electric warm air On Off

Thermostat

Coverplate

(optional)

Move the cycle rate switches

to the proper setting for your

system(seetablebelow).

Set cycle rate switches

1 2 3 4 5 6 7 8 9 ... 15 16

Sem comentários

Honeywell CT87K Manual do Utilizador Página 4