Honeywell TL8100A Manual de Instruções descarregar pdf

INSTALLATION INSTRUCTIONS

TL8100

7 DAY PROGRAMMABLE HYDRONIC THERMOSTAT

GUIDELINES

TURN OFF POWER TO THE HEATING SYSTEM AT

THE MAIN POWER PANEL TO AVOID ELECTRICAL

SHOCK. INSTALLATION SHOULD BE CARRIED OUT

BY AN ELECTRICIAN.

• For a new installation, choose a location about 5 ft.

(1.5 m) above the floor.

• The thermostat must be installed on an inside wall.

• Avoid locations where there are air drafts (top of

staircase, air outlet), dead air spots (behind a door),

direct sunlight, or concealed chimneys or stove pipes.

PROCEDURE

1. Loosen the captive screw securing the front mod-

ule to the rear module as shown in Fig. 1.

2. Lift the lower part of the front module to remove it

from the rear module.

3. Loosen the captive screw holding the terminal

cover and remove the cover.

4. Pass the wires through the opening to the right of

the terminals. See Fig. 2. Secure the rear module

to an electrical box or to the wall using the supplied

wall anchors and screws.

5. Connect the wires (see section “Thermostat Wir-

ing” on page 2). Use 12 AWG or smaller wire. 14

AWG is recommended for line voltage, 18 AWG is

recommended for 24 VAC.

6. Install the terminal cover and tighten the screw.

7. Configure the thermostat using the switches

located on the back of the front module (see sec-

tion “Thermostat Configuration” on page 3).

8. Install the batteries (see section “Power-up” on

page 3).

9. Mount the front module onto the rear module and

tighten the screw.

Fig. 1. Installation steps.

Fig. 2. Routing wires to thermostat.

M29963

SUPPLY

LOAD

PROVIDED

WIRES

M29964

1 2 3 4 5 6 ... 11 12

Resumo do Conteúdo

Página 1 - PROCEDURE

INSTALLATION INSTRUCTIONSTL8100 7 DAY PROGRAMMABLE HYDRONIC THERMOSTATGUIDELINESTURN OFF POWER TO THE HEATING SYSTEM AT THE MAIN POWER PANEL TO AVOID

Página 2 - THERMOSTAT WIRING

TL810069-2017EFS—03 10CABLEADO DEL TERMOSTATOFig. 25. Diagrama de cableado de un circulador de voltaje de línea.Fig. 26. Diagrama de cableado de un ca

Página 3 - POWER-UP

TL810011 69-2017EFS—03CONFIGURACIÓN DEL TERMOSTATOEn la Table 7 se muestra la configuración de los interruptores en la parte posterior del módulo fron

Página 4

TL8100Automatización y control desenlaceHoneywell International Inc.1985 Douglas Drive NorthGolden Valley, MN 55422customer.honeywell.com® Marca Regi

Página 5 - COMMENT FAIRE

TL810069-2017EFS—03 2THERMOSTAT WIRINGFig. 3. Wiring diagram for a line voltage circulator.Fig. 4. Wiring diagram for a line voltage electric heater.F

Página 6 - THERMOSTAT

TL81003 69-2017EFS—03THERMOSTAT CONFIGURATIONTable 1 shows the configuration of the switches on the back of the front module. Default settings are ins

Página 7 - MISE SOUS TENSION

TL8100Automation and Control SolutionsHoneywell International Inc.1985 Douglas Drive NorthGolden Valley, MN 55422customer.honeywell.com® U.S. Registe

Página 8

NOTICE D'INSTALLATIONTL8100 THERMOSTAT HYDRONIQUE PROGRAMMABLEDIRECTIVESCOUPER L'ALIMENTATION ÉLECTRIQUE DU SYSTÈME DE CHAUFFAGE AU TABLEAU

Página 9 - TERMOSTATO PROGRAMABLE

TL810069-2017EFS—03 6RACCORDEMENT DU THERMOSTATFig. 14. Schéma de câblage pour un circulateur sur tension secteur.Fig. 15. Schéma de câblage pour un c

Página 10 - Cableado del control remoto

TL81007 69-2017EFS—03CONFIGURATION DU THERMOSTATLe Table 4 illustre la configuration des interrupteurs au dos du module avant. Les réglages par défaut

Página 11 - ENCENDIDO

TL8100Solutions de régulation et d’automatisationHoneywell International Inc.1985 Douglas Drive NorthGolden Valley, MN 55422customer.honeywell.com® M

Página 12 - Golden Valley, MN 55422

INSTRUCCIONES DE INSTALACIÓNTL8100 TERMOSTATO PROGRAMABLEINSTRUCCIONESCORTAR LA ALIMENTACIÓN DEL SISTEMA DE CALEFACCIÓN EN EL PANEL CENTRAL PARA EVITA

Comentários a estes Manuais

Sem comentários

Honeywell TL8100A Manual de Instruções

Consulte online ou descarregue Manual de Instruções para Extensões elétricas Honeywell TL8100A. Honeywell TL8100A Instructions / Assembly Manual do Utilizador

Resumo do Conteúdo

Comentários a estes Manuais