Honeywell CTP-20 Manual do Utilizador descarregar pdf

IND.CONT.EQ.

3JHX

INSTALLATION INSTRUCTIONS

62-0245—01

Solid Core and Split Core 4-20 mA

Output Current Sensors

CTS-20; CTP-20

SAFETY

WARNING

For CTS-20 Series current sensors, ensure

that all power sources are disconnected and

locked out before installation as severe injury

or death may result from electrical shock due

to contact with high voltage wires.

CAUTION

This product is not intended to be used for life

or safety applications.

CAUTION

This product is not intended for use in any

hazardous or classified locations.

INSTALLATION

Make sure that all installations are in compliance with all

national and local electrical codes. Only qualified

individuals that are familiar with codes, standards, and

proper safety procedures for high-voltage installations

should attempt installation. The current sensor is a 2-

wire, 4 to 20 mA Loop Powered device that requires a

regulated +12 to 30 Vdc external power source.

IMPORTANT

The current switch should be used on insulated

conductors only!

The current sensors may be mounted in any position

using the two (2) #8 x 3/4 in (19 mm) Tek screws and the

mounting holes in the base or snapped directly on to the

1-3/8 in. (35 mm) DIN rail (See Figures 3 and 4). Leave a

minimum distance of 1 in. (25 mm) between the current

sensor and any other magnetic devices such as

contactors and transformers.

Fig. 1. Sensor placed on DIN rail

Fig. 2. Sensor removed from DIN rail

M25289

M25290

1 2 3 4

Resumo do Conteúdo

Página 1 - Output Current Sensors

IND.CONT.EQ.3JHXINSTALLATION INSTRUCTIONS62-0245—01Solid Core and Split Core 4-20 mAOutput Current SensorsCTS-20; CTP-20SAFETYWARNINGFor CTS-20 Series

Página 2 - 62-0245—01 2

SOLID CORE AND SPLIT CORE 4-20 MA OUTPUT CURRENT SENSORS62-0245—01 2WARNINGThe secondary of the 5A Current Transformer (C.T.) must be shorted together

Página 3 - OPERATING SPECIFICATIONS

SOLID CORE AND SPLIT CORE 4-20 MA OUTPUT CURRENT SENSORS3 62-0245—01aperture (hole) size of the current sensor is 3/4 in. (19 mm) and will accept a ma

Página 4 - CURRENT CONVERSION FORMULA

SOLID CORE AND SPLIT CORE 4-20 MA OUTPUT CURRENT SENSORSAutomation and Control SolutionsHoneywell International Inc. Honeywell Limited-Honeywell Limit