Honeywell 6160rf Manual do Utilizador descarregar pdf

K0903V1 2/06 Rev. B

ADEMCO 6160RF

Keypad/Transceiver

Installation and Setup Guide

GENERAL INFORMATION

The ADEMCO 6160RF keypad/transceiver is a combination unit that combines the functions of the following

devices:

• 6160 Alphanumeric Addressable Keypad

• 5881H RF Receiver

• 5800TM Transmitter Module

The 6160RF Keypad/Transceiver may be used on any control panel that supports 5800 Series wireless devices

(e.g., VISTA-10P, VISTA-15P, VISTA-20P).

FEATURES

• Supports wireless key transmitters (e.g.; 5804) and bi-directional transmitters (e.g.; 5804BD, 5828/5828V).

• Supports wireless keys with high-security (encryption) capability (e.g.; 5804E).

• Provides a nominal range of 200 feet' for RF transmitters (some transmitters have a shorter range).

• Supports RF jam detection when the receiver is enabled.

• Capable of sending status signals (Armed, Ready, etc.) to bi-directional units such as 5804BD, 5804BDV and

5828/5828V.

The following 5800 series transmitters are not intended for use in UL installations: 5802, 5804, 5804BD, 5804BDV, 5804E,

5814, 5816TEMP, 5819, 5819BRS, 5819WHS, 5828/5828V and 5850.

INSTALLING THE 6160RF

Locate the 6160RF in an area and at a height where

it is convenient for user operation. The 6160RF must

be at least 10 ft from the control panel to ensure

proper operation of the RF receiver.

Mounting and Wiring

The 6160RF has terminal blocks for connection to

power and data wires. Removing the keypad’s case

back provides access to the terminal blocks.

The 6160RF can be surface mounted directly to

walls, or to a single- or double-gang electrical box.

Follow these steps to mount and wire the keypad:

1. Push the two case release snaps at the bottom of

the keypad with the blade of a medium

screwdriver (this will push in the release snap),

then pull that side of the case back away. Insert

the screwdriver in the side of the keypad

(between the front and back case) and gently

twist to release the side locking tab. Repeat for

the other side. Refer to Figure 1 for location of the

case back release snaps and locking tabs.

ARMED

READY

MOUNTING

RELEASE

SNAPS

NOTE:

TO REMOVE REAR COVER

PUSH IN THE TWO MOUNTING

SNAPS LOCATED ALONG THE

BOTTOM OF THE KEYPAD

AND LIFT COVER UP.

6160RF-003-V1

LOCKING

TA B

Figure 1. Removing the Case Back

Pass the wiring from the control panel through

the opening in the case back. (see the control

panel’s instructions for proper run lengths.)

a. If surface wiring is being used, wiring may be

routed through the top or the bottom left-side

breakout in the case back. The breakouts must

be punched out using a screwdriver before

mounting the case back.

b. If desired, wires may be strain-relieved to the

wire tie point on the inside of the case back

with a tie wrap (not supplied).

3. Mount the case back to a wall or to an electrical

box using the 25mm-long self-tapping screws

supplied (mollies for drywall are not supplied).

Connect the power and data wires from the

control panel to the terminals on the 6160RF as

indicated in Figure 2 and Table 1.

6160RF-002-V1

WIRING TERMINALS

(TO CONTROL PANEL)

Figure 2 - 6160RF Wiring Details

1 2 3 4

Resumo do Conteúdo

Página 1 - ADEMCO 6160RF

K0903V1 2/06 Rev. B ADEMCO 6160RFKeypad/TransceiverInstallation and Setup Guide GENERAL INFORMATION The ADEMCO 6160RF keypad/transceiver is a c

Página 2 - ▲Y (Data In)

- 2 - Table 1 - Wiring Table Keypad Control Panel Wire Color G▼ (Data Out) Data In Green - -Aux Pwr (GND) Black + +Aux Pwr Red ▲Y (Data In) D

Página 3

- 3 - STEP DESCRIPTION DISPLAY CHOICES 4. (Receiver Address) If receiver is enabled, enter the two-digit receiver address. (01-30). Note: Refer

Página 4 - ‡K0903V1?Š

TROUBLESHOOTING The error messages listed in the following table cause the 6160RF to produce a single ding tone. The table describes the error messa

Comentários a estes Manuais

Sem comentários

Honeywell 6160rf Manual do Utilizador

Consulte online ou descarregue Manual do Utilizador para Sistemas de segurança - controlo de acesso Honeywell 6160rf. Honeywell 6160rf User's Manual Manual do Utilizador

Resumo do Conteúdo

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Honeywell 6160rf