Honeywell Scanner 1900 Manual do Utilizador descarregar pdf (Página 138)

7 - 2

All Symbologies

If you want to decode all the symbologies allowable for your scanner, scan the

All Symbologies On

code. If on the other hand, you want to decode only a

particular symbology, scan All Symbologies Off followed by the On symbol for

that particular symbology.

Note: When All Symbologies On is scanned, 2D Postal Codes are not enabled.

2D Postal Codes must be enabled separately.

Message Length Description

You are able to set the valid reading length of some of the bar code symbolo-

gies. If the data length of the scanned bar code doesn’t match the valid read-

ing length, the scanner will issue an error tone. You may wish to set the same

value for minimum and maximum length to force the scanner to read fixed

length bar code data. This helps reduce the chances of a misread.

EXAMPLE: Decode only those bar codes with a count of 9-20 characters.

Min. length = 09Max. length = 20

EXAMPLE: Decode only those bar codes with a count of 15 characters.

Min. length = 15Max. length = 15

For a value other than the minimum and maximum message length defaults,

scan the bar codes included in the explanation of the symbology, then scan the

digit value of the message length and Save bar codes on the Programming

Chart inside the back cover of this manual. The minimum and maximum

lengths and the defaults are included with the respective symbologies.

All Symbologies On

All Symbologies Off

1 2 ... 133 134 135 136 137 138 139 140 141 142 143 ... 297 298

Sem comentários

Honeywell Scanner 1900 Manual do Utilizador Página 138