Honeywell Scanner 1900 Manual do Utilizador descarregar pdf (Página 25)

1 - 3

2. Make sure the cables are secured in the wireways in the bottom of the

cordless base and that the base sits flat on a horizontal surface.

3. The scanner beeps.

4. Verify the scanner or cordless base operation by scanning a bar code

from the Sample Symbols in the back of this manual.

The unit defaults to a USB PC Keyboard. Refer to page 2-4 for other USB

terminal settings.

For additional USB programming and technical information, refer to “USB

Application Note,” available at www.honeywellaidc.com.

Connecting with Keyboard Wedge

A scanner or cordless base can be connected between the keyboard and

PC as a “keyboard wedge,” plugged into the serial port, or connected to a

portable data terminal in wand emulation or non decoded output mode.

The following is an example of a keyboard wedge connection:

1. Turn off power and disconnect the keyboard cable from the back of the

terminal/computer.

2. Connect the appropriate interface cable to the device and to the

terminal/computer.

Corded Scanner

Keyboard Wedge

Connection:

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 297 298

Sem comentários

Honeywell Scanner 1900 Manual do Utilizador Página 25